For a connector, electrical performance provides the role of resistance, so it is related to the safety factor of a circuit. The first is that there must be a step-down function at the end of the direct contact with the resistance. The voltage here refers to the voltage. The resistance of livestock has a high-quality electric power. Therefore, the connector should be fairly stable in order to control the safe transmission of the resistance without omission. The situation.

The contact value between connector and resistance is from several milliohms to ten milliohms. The middle value is selected according to different uses. The service life of a connector is directly related to its use. If the resistance is too large, the connector itself has a color change, and the heat and voltage endured will lead to it. The protective film on the outside of the connector was burned out, which caused serious internal damage.

But the emergence of insulation resistance is just to balance the use of such a state. Insulation resistance is used in this process to measure the insulation performance between the connector contact part and the connector shell. This part of the design itself has the function of resisting current, so it has been installed in the past. If there is a position error in the process, it will directly lead to the circuit may be damaged because the resistance is too large or it can not be used at all.

Its quantity is much higher than that of contact resistance, and the maximum is up to gigaohms. Therefore, special attention should be paid to this connection and application in use. Only by mastering this skill can we better control the electric connector, and truly control the installation of a circuit within a safe current range. Inside. In addition, the resistivity is also an indispensable part of the voltage, here the test is the ability to withstand external voltage, and its own material has an inseparable relationship.